Post by ronr on May 26, 2007 11:54:18 GMT -5
This doesnt seem like a lot of progress but it is more than you think:
Scratch built the Magneto and drilled the valve covers, Used 3/16 inch pieces Of .030 wire insulation for plug boots.
Used .017 wire for the Oil Lines. Arduns require a return line from the valve cover to the pan. Line coming from pan to back of block is the return line from the Oil Bath Filter. The line in the rear of the block is the feed line to the Oil Bath filter.
Thats about all I can do until the Blower arrives from RMM.
Scratch built the Magneto and drilled the valve covers, Used 3/16 inch pieces Of .030 wire insulation for plug boots.
Used .017 wire for the Oil Lines. Arduns require a return line from the valve cover to the pan. Line coming from pan to back of block is the return line from the Oil Bath Filter. The line in the rear of the block is the feed line to the Oil Bath filter.
Thats about all I can do until the Blower arrives from RMM.
