Post by snacktruck on Nov 9, 2007 23:24:02 GMT -5
I have been having trouble with Testor’s Decal making kit. I have both clear and white paper. I also have the required bonding spray. I have printed good clean graphics on the decal sheet, sprayed a couple of times with the bonding spray. Done this several times. Varied the amount of spray each time on a cleanly printed paper, so as to make sure I got the spray down right. Every time I got to use these decals, they loosen up just fine, but as soon as I get the decal to start sliding on to the model, the leading edge curls up and I cannot get it to straighten out. To me I feel like there is not enough spray on it, but I have gone from moderate to heavily moderate. The instructions say not to use too much.
My question is there an alternative way of doing your own decals with some other paper and spray. Any help would be greatly appreciated. Thanx in advance.
My question is there an alternative way of doing your own decals with some other paper and spray. Any help would be greatly appreciated. Thanx in advance.
